Maintenance; Troubleshooting - HART HLPH02 Operator's Manual

MAINTENANCE

WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Hearing and/or head pro-
tection may also be required depending on the type of
attachment used and as prescribed in the attachment's
Operator's Manual. Failure to do so could result in ob-
jects being thrown into your eyes and other possible
serious injuries.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Never use water or any liquids to clean or rinse off your
product and do not expose the product to rain or wet
conditions. Store indoors in a dry area. Corrosive liquids,
water, and chemicals can enter the product's electronic
components and/or battery compartment and damage
electronic components and/or the battery pack, which
can result in a short circuit, increased risk of fire, and
serious personal injury. Remove any buildup of dirt and
debris by wiping the product clean with a dry cloth oc-
casionally.

TROUBLESHOOTING

PROBLEM
Motor fails to start when switch
trigger is depressed
POSSIBLE CAUSE
Battery is not secure.
Battery is not charged.
8 – English
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petro-
leum-based products, penetrating oils, etc., come in con-
tact with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
CLEANING THE POWER HEAD
 Stop the motor and remove the battery pack.
 Clean dirt and debris from the power head using a damp
cloth with a mild detergent.
NOTICE:
Do not use any strong detergents on the plastic housing
or the handle. They can be damaged by certain aromatic
oils such as pine and lemon, and by solvents such as
kerosene.
STORING THE POWER HEAD
 Remove the battery pack from the power head before
storing.
 Clean all foreign material from the power head.
 Store it in a place that is inaccessible to children.
 Keep away from corrosive agents such as garden chem-
icals and de-icing salts.
To secure the battery pack, make sure
the latch snaps into place.
Charge the battery pack according to the
instructions included with your model.
SOLUTION