Using The Optiview Wireless Network Analyzer; Starting The Optiview Wireless Network Analyzer - Fluke OptiView Getting Started Manual

Wireless network analyzer

Hide thumbs Also See for OptiView:

Table of Contents

OptiView

Getting Started Guide

Using the OptiView Wireless Network Analyzer

At the desktop, press the OptiView Wireless Network Analyzer

(OPVWNA-V2) icon to launch the software.

The OptiView WNA, running on an OptiView Classic ( running

Windows 98), and the OptiView

software should not be run at the same time. Shut down the

OptiView

before starting the OptiView Wireless Network Analyzer software.

If you are running Windows Service Pack 2 on the Windows XP

operating system, the firewall should be turned off for efficient

discovery. If the firewall is turned on, you will be prompted with the

following screen after launching the software:

Figure 7. Allowing Discovery Through the Windows XP Firewall

Select Unblock to allow limited discovery by the OptiView Wireless

Network Analyzer on the wireless network. The wireless discovery

will take about a minute longer to update the screen and some

discovery will be compromised. If you select Keep Blocking, no

discovery will take place.

Integrated Network Analyzer user interface software

Note

Integrated Network Analyzer

Note

apo32s.bmp

Table of Contents

Do you have a question about the OptiView and is the answer not in the manual?