Trial Sewing - JUKI MO-623N Instruction Manual

Trial sewing

Thread tension dial
Decrease
Increase
After threading, make a trial sewing.
Be sure to use a double layer of fabric in order to check whether the
seam and thread tension are adequate.
1. Set all of the thread tension dials at "4".
2. Make sure that the upper knife is lowered (in the cutting posi-
tion).
3. Raise the presser foot.
4. Place the fabric under the presser foot.
5. Lower the presser foot and sew.
6. At the end of the seam, continue sewing to form a 5 to 6 cm long
thread chain.
7. Holding the fabric with one hand, pull the thread chain over the
thread cutter on the presser foot shank.
・ Thread tension dial should be properly adjusted according to
the types of fabrics and threads to be used.
Adjusting the thread tension
Imperfect stitch formation can be corrected by adjusting the set
value (1 to 9) on the thread tension dial.
Types of needle
A Upper looper thread tension adjusting dial
B Lower looper thread tension adjusting dial
C
Needle thread tension adjusting dial
Turning to the right increases the thread tension.
Turning to the left decreases the thread tension.
When using filament thread or woolly nylon thread, adjust the
thread tension accordingly.
Standard of the thread
tensioner dial
3 - 5
3 - 5
3 - 5
18