Advertisement
Quick Links
BattenFit Sensor with Regulating Photocell
MSB1000DT for use with DSI ballasts
MSB1000DALIT for use with DALI ballasts
Installation and Commissioning
Instructions
Note: QuickSet Pro or HP18* required for commissioning
* Please note that the HP18 offers different/limited programming options
Advertisement
Related Manuals for Honeywell Ex-Or MSB1000DT
Summary of Contents for Honeywell Ex-Or MSB1000DT
- Page 1 BattenFit Sensor with Regulating Photocell MSB1000DT for use with DSI ballasts MSB1000DALIT for use with DALI ballasts Installation and Commissioning Instructions Note: QuickSet Pro or HP18* required for commissioning * Please note that the HP18 offers different/limited programming options...
- Page 2 BattenFit Sensor with Regulating Photocell: MSB1000DT - for use with DSI ballasts MSB1000DALIT - for use with DALI ballasts Only suitably qualified personnel should install this equipment. This passive infrared presence detector is designed to be fitted to a batten-style luminaire. Installation 1.
- Page 3 Electrical Connections Fig. 5 Always check product label before connecting. Do not connect the SUPPLY Dimming Signal Pair L N E of one detector to that of another detector. Blue Brown White White Note: White/White Dimming Signal Pair is Polarity Free. L N E L N E L N E...
-
Page 4: Detection Zone
Detection Profile Plan View Detection pattern is a 360 cone shape. Diameter is 2.25 x the mounting height. The squares show the arrangement of the detection pattern. BATTEN LUMINAIRE Fig. 7 2.5m Direction of most commonly used entry into detection zone, i.e. - Page 5 Setting the Regulating Photocell This product is intended for use with high frequency regulating ballasts with digital control inputs. An infrared programming tool QuickSet Pro or HP18 is required for programming the regulating light level set point. The setting is preserved in the event of a power failure and can be re-programmed any number of times. Using the QuickSet Pro: Enter the Utilities menu, then choose ‘LightSpot/MLS/LCM’...
- Page 6 Walk Testing In order to verify the installation, there is an inbuilt facility (Walk Test Mode) to temporarily reduce the time delay to 10 seconds. A QuickSet Pro or HP18 Programmer is required to access this facility. Using the HP18: Press the ‘TEST’...
- Page 7 Parameter Options Pre-Set Notes Sets the luminaire state at power up irrespective of occupancy. Power Up On / Off Useful in reducing start-up load following power cut. Power- up off - responds to occupancy after 30 seconds. Response Auto / Semi-auto Auto If set to auto, the presence detector switches the luminaire on and off automatically.
-
Page 8: Technical Data
MSB1000DALIT - 4 x DALI ballasts WEIGHT: 100g COLOUR: White RAL9010 MATERIAL: Flame retardant PC IP RATING: 4X - estimated Honeywell Ex-Or Albery House, Springfield Road, At the end of their useful life Horsham, West Sussex RH12 2PQ the packaging and product...