Safety Notes
relating to Lithium-Ion-Polymer batteries
These operating instructions for the battery
charger can only provide a global overview of
the methods of charging and handling
rechargeable Li-Poly batteries, and should
not be considered as a substitute for the
instructions provided by the battery manu-
facturer.
Please be sure to read the instructions and
information supplied by the battery manu-
facturer.
- Be sure to place the battery on a fireproof,
non-flammable surface for charging and
discharging, and never leave the pack on
charge unsupervised.
- Do not submerge the battery in water or
any other liquid, as this may cause damage
to the monitor module; this in turn could
cause the pack to be charged at an abnor-
mal current or voltage.
- Do not heat the battery, throw it into a fire
or place it in a microwave oven.
- Do not short-circuit the pack or charge it
with reverse polarity.
- Do not subject the battery to physical pres-
sure; do not deform or throw it.
- Do not solder directly to the battery.
- Do not modify or open the battery.
- Do not charge the battery to a voltage hig-
her than 4.2 (4.1) Volts per cell.
- Do not discharge the battery to a voltage
lower than 2.5 (2.4) Volts per cell.
- These batteries may only be charged using
a charger designed expressly for this pur-
pose. Never connect the battery directly to
a mains PSU.
Supplementary operating instructions
POWER PEAK Infinity 2 LI
13
- Never charge or discharge the battery in
direct sunshine, or close to a heater or fire,
as this might damage the monitor module.
- Do not use the battery in any location
which is subject to severe static dischar-
ges.
- Any of these errors may cause the bat-
tery to be damaged, explode or catch
fire.
- Keep the battery well out of the reach of
children.
- If electrolyte should escape, keep it well
away from fire. The substance is highly
inflammable and may burst into flames.
- Avoid the fluid electrolyte contacting your
eyes. If this should occur, rinse the
affected part immediately with plenty of
clean water before seeking medical atten-
tion.
- If the fluid electrolyte should contact your
clothes or any other object, immediately
wash it off using plenty of water.
- Be sure to read and observe the general
safety notes regarding battery charging.
These are included in the main operating
instructions for the charger.
Order No.
8294Li/D
Need help?
Do you have a question about the Robbe Power Peak Infinity 2 and is the answer not in the manual?
Questions and answers
What is the voltage limits on the power input?
The voltage limits for the power input of the Robbe Power Peak Infinity 2 are 11 to 15 volts DC.
This answer is automatically generated