Bottom Shield - HP Chromebox G3 Maintenance And Service Manual

3. Remove the I/O side frame (3) by swinging it up and out of the Chromebox.
To replace the I/O side frame, reverse the removal procedures.

Bottom shield

To remove the bottom shield, use this procedure and illustration.
Table 6-3 Bottom shield description and part number
Description
Bottom shield
Before removing the bottom shield, follow these steps:
1. Prepare the Chromebox for disassembly
2. Remove the bottom cover
3. Remove the I/O side frame
Remove the bottom shield:
1. Remove the four Phillips M2.5 × 5.0 screws (1) that secure the bottom shield to the Chromebox.
2. Detach the bottom shield front protective strip (2) and the bottom shield padding (3) from the bottom
shield. (The bottom shield front protective strip is attached to the bottom shield with double-sided
adhesive.)
The bottom shield front protective strip is included in the Shield Kit, spare part number L20217-001.
3. Release the bottom shield (4) as far as the power connector cable will allow.
ENWW
(Preparation for disassembly on page
(Bottom cover on page 27).
(I/O side frame on page 28).
Spare part number
M41139-001
27).
Component replacement procedures 29