Mitsubishi Electric P-RCC-E Installation Manual page 3

5. Installation method
Remove the front casing.
1) Remove the filter cover and the filter case towards your side
(three locations).
Filter case
2) Remove the screws from the front casing (VL-350: four
locations, VL-250: two locations).
Remove the front casing.
Screw
（VL-350 only）
Screw
Front casing
Removing the remote controller.
1) Remove the front cover of the remote controller.
Insert a flat-tip screwdriver (blade width: 5 mm) into the
latches at the bottom of the remote controller, and move it in
the direction of the arrow as shown. Remove the front cover
by pulling it towards you as the latches will be unhooked.
Note:
- Do not insert the flat head screwdriver forcefully. (Damage
on the circuit board could result.)
- Do not turn the flat head screwdriver forcefully while it is
inserted into the latch. (Damage on the case could result.)
2) Remove the remote controller from the unit.
1 Remove the screws attaching the bottom case and the
unit (two locations).
2 Remove the connector of the terminal cable from the
connector of the lead wire on the unit side.
- Leave the removed connector of the lead wire on the
unit side.
3 Remove the remote controller from the unit.
2 Connector
①Screw
*The illustrations show VL-350CZPVU-R-E.
Filter cover
Front casing
Front cover
OPEN
Lead wire on the unit side
Terminal cable
Bottom case
Attach the RC COVER.
1) Remove the two screws from the base plate.
2） Attach the RC COVER with the screws removed in 1).
RC COVER
Screw
Reassembly and checks after installation
CAUTION
Securely install parts.
Injuries could result if the unit falls.
1. Attach the front case.
2. Attach the filter case and the filter cover on the unit.
Install the cable with noise filter.
1) Remove the two screws from the control box and pull it out.
Remove the insulating sheet from the control box.
Insulating sheet
2) Detach the connectors of the TM4 cable and the lead wire on
the unit side. Attach the accessory terminal protective cap on
the connector of the lead wire on the unit side.
Lead wire on the unit side
TM4 cable
3) Connect the connector of the accessory cable with noise filter
to the TM4 cable.
TM4 cable
3
Control box
Screw
Terminal protective cap
Connector
TM4 cable
Cable with noise filter
Base plate
Screw