Chapter 2 Hardware Installation; Hardware Installation Steps; Checking Motherboard's Jumper Setting - Intel P55 User Manual

Express chipset based m/b for intel lga 1156 processors
Table of Contents

Advertisement

Turn off your power when adding or removing expansion cards or
WARNING!
other system components.
damage to both your motherboard and expansion cards.
2-1

Hardware installation Steps

Before using your computer, you had better complete the following steps:
1. Check motherboard jumper setting
2. Install CPU and Fan
3. Install System Memory (DIMM)
4. Install Expansion cards
5. Connect IDE Front Panel /Back Panel cable
6. Connect ATX Power cable
7. Power-On and Load Standard Default
8. Reboot
9. Install Operating System
10. Install Driver and Utility
2-2

Checking Motherboard's Jumper Setting

(1) CMOS RAM Clear (3-pin): JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM
short 1-2 pins of JBAT to store the CMOS data.
ATTENTION: Please unplug the AC power before you Clear CMOS.
To clear the CMOS, follow the procedure below:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JBAT and short pins 2-3 for a few seconds
4.
Return JBAT to its normal setting by shorting pins 1-2
5.
Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1. Troubleshooting
2. Forget password
3. After over clocking system boot fail
Chapter 2
Hardware Installation
8
Failure to do so may cause severe

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents