Switching On Or Reset; Start; Stand-By - Jacuzzi cloud Use & Maintenance

Electronic
functions

switching on or reset

start

stand-by

Check that the hydraulic and electrical output are functioning and connect the power
to the shower enclosure: a check procedure is started and the steam generator is auto-
matically rinsed.
During this phase, which lasts a couple of minutes, no function may be activated.
After this preliminary check, the keys are illuminated with a white light with reduced
intensity:
After switching on, the shower enclosure switches to the "start" mode.
BASE - DREAM
The control panel remains off.
HOME SPA
The key flashes.
In "start" mode, it is possible to set the password for the Bluetooth® connection (refer to the
respective paragraph).
BASE - DREAM
This mode occurs each time an electronic function is turned off; the control panel
shows the keys illuminated (white light).
HOME SPA
After pressing the centre of the control panel, the system switches to "stand by" mode: all
the keys illuminate and flash.
After pressing the key, the system switches to "stand by" mode: all the keys on the
control panel illuminate except those for the audio functions.
The audio function keys only illuminate when there is a Bluetooth® connection.
In "stand by" mode, it is possible to activate the electronic functions (refer to the respec-
tive chapters).
If no key is pressed for a few seconds, the control panel will switch to "start" mode.
36