Rails; Detaching The Shelf Supports; Refitting The Shelf Supports; Appliance Door - Bosch VGD553FB0 Instruction Manual

Rails

en
pRails
D etaching the shelf supports
R a i l s
The shelf supports are each fixed to the side panels of
the cooking compartment at three points.
Grip the front of the shelf support and pull it round to
1.
the middle of the cooking compartment.
The front hook of the shelf support will come out of
the hole.
Swing the shelf support round further and pull it out
2.
of the rear holes in the side panel.
Remove the shelf supports from the cooking
3.
compartment.

Refitting the shelf supports

Insert the hooks of the shelf support into the rear
1.
holes in the side panel.
Push the front hook of the shelf support into the
2.
hole.
16
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the

appliance door.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels
from the oven door.
Removing the door panels
Open the oven door fully.
1.
Lock the two hinges on the left and right using the
2.
locking pin.
The locking pins must be fully inserted into the
Note:
holes in the hinges.
Lift the bottom of the inner panel slightly until the
3.
fastening pins come out of the holder (1).
Carefully lift the top of the inner panel until the
4.
fastening pins come out of the holder (2).
Remove the inner panel.
5.
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Fitting the door panels
Reinsert the inner panel.
1.
All four fastening pins must engage in the
Note:
holders provided for them.
Remove the locking pins and close the oven door.
2.