Furuno FELCOM 15 Operator's Manual page 52

14. Press the [Enter] key to open the destination type window.
TELEX: Telex communication
Facsimile service
FAX:
- to an office facsimile machine
E-Mail: E-mail (electronic mail) Service
CSDN: Circuit Switched Data Network-not used.
PSDN: Packet Switched Data Network
- to an office computer via a data network using X.25 standard.
For future use
X400:
Data Network ID -not used.
DNID:
SPEC: Ship-to shore requests for safety service, accessed by using special
2-digit codes (See Note 2 below.)
Note 1: When FAX is selected, choose "T30 (FAX)" in the "Modem Type"
options window. For further details, refer to paragraph 4.1.2.
Note 2: When SPEC is selected on the Type line, the Country Code line
disappears. Enter two-digit codes on the Station ID line. Refer to
paragraph 4.1.7.
15. Set up according to Destination Type selection. The steps which follow show
how to set up for TELEX (Prefixed).
16. Press the [Enter] key to close the destination type window.
17. Press the [↓] key to choose Prefix Code.
18. Press the [Enter] key to open the prefix code window.
19. Key in prefix code in two digits. (Some services may not be available
depending on LES.)
P e r
TELEX
FAX
E-Mail
CSDN
PSDN
X400
DNID
SPEC
TELEX (Prefixed)
FAX (Prefixed)
PSDN (Prefixed)
X400 (Prefixed)
DNID (Prefixed)
SPEC (Prefixed)
Options window for "destination type"
x i f C o d e
1 1 O e p a r o t s ' r A
2 1 D l a i G i u e d
3 3 T c e n h c i l a A
1 9 A u o t m a c i t T
2. SYSTEM INITIALIZATION
F u n t c o i n
s s t s i n a e c
s s t s i n a e c
l e x e T e t s
2-23