Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Young 27106
Summary of Contents for Young 27106
- Page 1 METEOROLOGICAL INSTRUMENTS INSTRUCTIONS PROPELLER ANEMOMETER MODEL 27106 R.M. YOUNG COMPANY 2801 AERO PARK DRIVE, TRAVERSE CITY, MICHIGAN 49686, USA TEL: (231) 946-3980 FAX: (231) 946-4772 WEB: www.youngusa.com PN: 27106-90 REV: G062819...
- Page 2 INTRODUCTION MODEL 27106 The Gill Propeller Anemometer is a low threshold precision air GILL PROPELLER ANEMOMETER velocity sensor employing a fast response helicoid propeller. The instrument uses a high quality tach-generator transducer which converts propeller rotation to a DC voltage that is linearly proportional to air velocity.
- Page 3 Allow 0.010 inch (0.25 mm) end play gap between shaft within ±30 degrees. Using the multiplier is NOT necessary when the collar/coupling disk and bearing. Tighten set screw (80 oz anemometer is used in a UVW configuration with YOUNG Model in, 5600 gm-cm max torque). 26800 Programmable Translator.
- Page 4 Liability is limited to repair or replacement of defective item. A copy Holmes, R. M., Gill, G. C., and Carson, H. W., “A Propeller Type of the warranty policy may be obtained from R. M. Young Company. Vertical Anemometer”, Journal of Applied Meteorology, CE COMPLIANCE Vol 3, 1964, pp.
- Page 5 PROPELLER CALIBRATION TABLE 08274 PROPELLER 27106-90(G) Page 4...
- Page 6 PROPELLER RESPONSE - WIND ANGLE OFF AXIS RESPONSE DATA 08274 PROPELLER 27106-90(G) Page 5...
- Page 7 ARMATURE RESISTANCE: 32 OHMS CABLE CONNECTOR TACH-GENERATOR 470 uF 6.3 V NON-POLARIZED CABLE CONNECTOR / MOUNT (PIN DESIGNATIONS) R. M. YOUNG COMPANY 2801 Aero-Park Drive , Traverse City, Michigan 49686 U.S.A. TEL (231) 946-3980 FAX (231) 946-4772 27106-90(G) Page 6...
- Page 8 DWG: E05106-90(B) REV: B062819 CHK: MANUAL REPLACEMENT PARTS DRAWING DRW: JMT DATE: 02/13/18 27106 GENERAL ASSEMBLY & REPLACEMENT PARTS 27106-90(G) R. M. YOUNG COMPANY 2801 Aero-Park Drive , Traverse City, Michigan 49686 U.S.A. Page 7 TEL (231) 946-3980 FAX (231) 946-4772...
Need help?
Do you have a question about the 27106 and is the answer not in the manual?
Questions and answers