Fault Shutdown And Troubleshooting; Led Status Panel - YASKAWA Solectria PVI 25TL-480-R Installation And Operation Manual

Installation and Operation Guide SOLECTRIA PVI 25TL-480-R
5.2.5 Turn On / Off
Manual Turn ON/OFF: Manual Power ON/OFF is required after regulation setting or manual (fault) shut-down. Select
the submenu "Turn ON/OFF".

Turn ON: Click "Turn ON" and "OK" to start the inverter, the inverter will start up and operate normally if the start-
up conditions are met. Otherwise, the inverter will go to stand-by mode.

Turn OFF: Normally, it is not necessary to Turn OFF the inverter, but it can be shut down manually if regulation
setting or maintenance is required. Click "Turn OFF" and "OK", then the inverter will be shut down.
Automatic Turn ON/OFF: This is the standard inverter running mode while the inverter is turned on. The inverter will
start up automatically when the PV array output voltage and power meet set values, AC power grid is normal, and the
ambient temperature is within the allowable operating range. The inverter will be shut down automatically when the
output voltage and power of PV modules are lower than the set value, AC power grid fails, or the ambient
temperature exceeds the allowable operating range.

6. Fault Shutdown and Troubleshooting

LED Status Panel

6.1
Please see Section 1.4 for the LED Status Panel explanation.
DOCR-071030-A (11/17/2020)
Figure 5-18 History Submenu
INFO ✔
Page 76 of 101