Instruction Manual And The Utility Software; How To Install The Instruction Manual And The Utility Software; Procedure To Install The Instruction Manual And The Utility Software - Fujikura 90S Instruction Manual

Instruction Manual and the Utility Software

How to install the instruction manual and the Utility Software

The splicer has the instruction manual and the utility software on its hard drive.
You can install both onto a Windows PC with the following procedure.

Procedure to install the instruction manual and the utility software

1. Turn on the power of the splicer, then connect the splicer to the PC with a
USB cable.
2. A confirmation window will open. Tap [Yes] to start the USB Drive Mode. *
*If the window doesn't open, tap [Home]→ [Other Settings] → [Machine
Settings] icons to open the Machine Settings menu. Then set the [USB
Drive Mode] in the [Basic Settings] group to [Enable]. Then tap [Reset] to
go back to the [READY] screen.
3. Open the Windows Explorer on the PC. You will find an attached drive named
"SPLICER" and a file named "Install" or "Install.bat" on the drive.
4. Right click on "Install" or "Install.bat", then select "Run as administrator" in the
pop-up window. If a confirmation message appears, click "Yes" to continue
the installation.
5. The utility software opens automatically after the installation. Shortcut icons
for the instruction manual and the utility software will appear on the desktop
at the same time.
6. Disconnect the USB cable to finish the USB drive mode.
To open the instruction manual, double-click the shortcut icon on the desktop or
click [Instruction Manual (PDF)] button on the menu of the utility software.
Note1: If it is failure to install the DataConnection to your PC, confirm whether
the PV can connect to internet or not at first.
Note2: During installing this software, the software allows you to access to
Fujikura web site,
administrator of your PC.
90
"www.fujikura.co.jp/dev/splicers/ ", ask to