Hitachi RZ-V100CYH Operating Instruction And Cook Book page 32

Cleaning and Maintenance (cont.)
Non-water supply auto steamer (Plate and inner lid) (wash after each use)
●The non-water supply auto steamer is composed of the inner lid and plate.
●Remove the steam cap from the lid and wash it using neutral dishwashing detergent and a sponge or similar soft material.
1
Remove the non-water supply auto steamer
from the lid.
While holding the lid tab, push up the release lever.
Do not tilt the non-water supply auto
ATTENTION
steamer when carrying it. Otherwise,
water or hot water may spill from it.
Li Lid ta tab Lid tab
2
Separate the non-water supply auto
steamer into the inner lid and the plate.
Push down the plate lever and remove the plate.
Hot water and water will spill out, so
ATTENTION
take it apart in a sink.
Lever Lever
Do not pull the packing attached to the plate. It is not
detachable. If the packing is deformed, the amount
of water that collects in the plate will be reduced.
3
Wash away any dirt on the plate, or
clogs in holes in the plate.
4
Wash the inner lid to clean and unclog it.
Notes on attaching the non-water supply auto steamer
Lid packing
Auto steamer Auto steamer
Hook
If either of the hooks on both sides is not inserted
into the slot in the lid, the hooks may be damaged
or deformed when the lid is closed.
E-32
b
lev eve ver
Inner lid Inner lid
Lid Lid
Slots in the lid
5
After rinsing, wipe away all moisture and dry
thoroughly.
6
Attach the plate to the inner lid.
Do not attach the plate upside down.
Insert the lower hook of the plate into the lower guide on the inner lid.
1
Prevent the lid packing from being caught.
Align the upper hook of the plate with the upper guide, and
2
push the plate until it clicks into position.
e e ever e e e e e v e v er v ver v e r
Lo Low L Lower hook ower hook ower hook o e owe wer hook
7
Attach the non-water supply auto steamer to the lid.
Insert the hooks into
1
the slots with the lid
packing facing forward.
If you fail to insert both
hooks, they may be
damaged when the
inner lid is closed.
Plate Plate
Push the release lever up
2
and push the upper part
of the inner lid into place.
3 Move the release lever
down.
To prevent cooking from being
able to be started if you forget
to install the non-water supply
auto steamer, the lid will not
close with moderate force.
(The lid closes when the inner
pot is not set.)
Both hooks are
inserted into the
slots.
Hooks are not
inserted into
slots.
L o L L Lo Low Lower guide ower guide owe owe we e e
h h oo o k k k k k k k
Upper
guide
Upper
hook
Hook Hook k
1
1
3 3
2