Download Print this page

GenTent 20K Manual page 2

For generac 15k/17.5k addendum

Hide thumbs Also See for 20K:

INSTALL GTUs

- Remove one of the top bolts which secures the electrical panel to the frame using the 5/16" socket and/or

open end wrenches (Fig D.)

- Position one GTU flush over the electrical panel, align the hole and re-install the bolt through the GTU, the

electrical panel and the frame (Fig E.)

- Note that the two GTU's included will have holes that are opposite each other (a Left and a Right), or will

have all four holes open

- Optionally, drill a 5/32" hole through the frame where the bottom hole aligns with the frame and install the

included #12x3/4" sheet screw

- Fig. F shows a GenTent clamp subsequently installed onto the GTU.

Fig. D

Fig. E

Fig. F