Advertisement
3. OPERATION
WARNING! Ensure that you have read and understood Section 1 safety instructions before commencing.
3.1 Ensure all measuring surfaces are clean and then turn on micrometer by pressing on/off control. Wait at
least one second before use.
3.2 If read-out does not show zero when micrometer is in closed position, reset by pressing zero control.
3.3 Select inch or mm units, as required, with the metric/imperial selector. Check that display shows the required
units.
3.4 Retract the measuring pin by pressing the red lever above the display. Introduce the object to be measured into
the measuring space and allow the pin to close onto the object so that it is between the end of the pin and the
measuring pad.
3.5 Measurements will now be shown directly on the LCD display.
3.6 A new zero may be obtained, at any open position for relative and tolerance readings, by pressing the
zero control.
4. BATTERY FITTING
A flashing display indicates that the battery is exhausted - replace as follows:
4.1 Switch off and then remove battery cover by firmly sliding downwards. When the two tags are exposed, lift
off the battery cover as shown in fig.2A.
4.2 Remove exhausted battery and fit replacement with positive side uppermost (fig.2B).
4.3 Refit the battery cover by placing it over the battery in the position shown in fig.2A. Press lightly on the
cover and push up to close the compartment.
4.4 Dispose of old battery in a safe and approved manner. Do not burn.
If the display fails to alter when the slide is moved, remove the battery - wait at least 30 seconds and
then refit the battery.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which is
When the product is no longer required, it must be disposed of in
an environmentally protective way.
Refer to section 4.1 above re battery removal.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
compatible with the environment.
Battery Removal
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
fig.2
Under the Waste Batteries and
Accumulators Regulations 2009, Jack
Sealey Ltd are required to inform potential
purchasers of products containing
batteries (as defined within these
regulations), that they are registered with
Valpak's registered compliance scheme.
Jack Sealey Ltd's Batteries Producer
Registration Number (BPRN) is
BPRN00705
01284 757500
W e b
01284 703534
email
AK9638D
www.sealey.co.uk
sales@sealey.co.uk
Issue No.1 22/06/10
Advertisement
