Sealey AK9623EV Instructions

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. Safety
Warning! ensure Health and safety, local authority and general workshop practice regulations are adhered to when using tools and
‰
equipment.
dO nOt use if damaged.
8
maintain calliper in good and clean condition for best performance.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
9
dO nOt use the calliper for any purpose other than for which it is designed.
8
dO nOt get calliper wet or use in damp or wet locations, or areas where there is condensation. Keep calliper clean and dry using a
8
dry cotton cloth only.
dO nOt dip or submerge the calliper in any type of liquid.
8
dO nOt expose calliper to bright sunlight or dust.
8
dO nOt disassemble. The calliper must be checked by qualified service personnel only.
8
dO nOt apply any voltage to the calliper i.e. with an electric marker pen.
8
The calliper is a precision instrument, treat with care, avoid using force and do not subject to knocks or shocks.
9
use in reasonably constant temperature conditions of approximately 20°c.
9
When not in use, turn off and store gauge in a safe, dry, childproof location.
9
2. intrOductiOn
Hardened and tempered stainless steel digital calliper with satin finish. 11mm High figures in LCD display for ease of reading. Metric and
Imperial calibration with conversion between the two. Zero setting control allows for comparative measurement. Supplied in carry-case.
3. SpecificatiOn
model no: ..............................................................AK9623eV
range: ........................................................ 0-300mm (0-12")
resolution: .................................................0.01mm (0.0005")
Accuracy<100mm: .....................................±0.02mm (0.001")
Accuracy>100mm: .....................................±0.04mm (0.002")
2 3
1
11
7 8
6
© Jack sealey limited
instructions for
digital vernier caliper 0-300mm/0-12"
model no:
4
9
5
Original Language Version
aK9623ev
10
1 Internal measure
2 metric/imperial selector
3 locking screw
4 ABs/0 switch
5 LCD display
6 external measure
7 on/off control
8 Zero control
9 Battery cover
10 Depth measure
11 Step measure
AK9623EV | Issue 2(L) 10/07/17