Kernau KFWD 8656144 User Manual page 79

FAULT
Too much detergent has been used The
laundry is too dirty for the programme
Unsatisfactory
washing result.
As soon as the
machine is loaded
with water, water
discharges.
No water appears
No fault. Water is in the unseen part of
in the drum during
washing.
There is detergent
residue on your
detergents may appear on your laundry
laundry after
washing
There is detergent
residue on your
There is untreated oil, cream or laundry
laundry after
washing
Spinning operation
No fault. The Unbalanced load control
is not performed or
runs late.
Laundry remains
damp after the
drying operation.
POSSIBLE CAUSE
you have selected.
Not enough detergent used.
There is too much laundry in your
machine.
The end of the water drain hose is too
low for the machine.
the drum.
Non-dissolving particles of some
as white spots.
system has been activated.
Appropriate drying programme is not
selected. The maximum load capacity
for the selected programme might be
exceeded.
TROUBLESHOOTING
Select programmes appropriate for your
laundry's level of dirtiness.
Use the amount of detergent as instructed
on the packaging
Check that the maximum capacity of
your Washer Dryer is not exceeded.
Set the water drain hose to an
appropriate height.
__________
Perform an extra rinse, or clean your
laundry with a brush after it dries
Use the amount of detergent as instructed
on the packaging in the next wash
The Unbalanced load control system will
try to spread your laundry evenly. The
spinning operation will begin once your
laundry is evenly spread.
Place the laundry in the machine in a
balanced fashion next time.
Select a drying programme appropriate
for your laundry.
EN
79