Optional Accessories - Makita TD0101 Instruction Manual

Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
► 1 . Screwdriver 2. Brush holder cap
To maintain product SAFETY and RELIABILITY,
repairs, carbon brush inspection and replacement, any
other maintenance or adjustment should be performed
by Makita Authorized Service Centers, always using
Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Screw bits
• Socket bits
• Bit piece
• Adjustable locator with bit
• Hook
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
1
2
Hook
► 1 . Screw 2. Hook 3. Groove
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
• Adjustable locator with bit
Adjustable locator with bit
1
2
► 1 . Bumper 2. Hammer case cover
To use the adjustable locator with bit, remove the
bumper and then install it. The bumper can be removed
by pulling forward.
7 ENGLISH
3
1
2