Advertisement
OPERATION
1
LOW INPUT
PWR
R
L
After initial set-up, the amplifier should not require any
further adjustment unless there is a change in the car
stereo or speaker system with which it is used.
1
Power Indicator LED
The Power Indicator LED will light to indicate that the
unit is connected to the battery and that the Remote
Turn-On terminal is receiving +12 volts, thus turning
on the amplifier.
2
Level (Gain) Control
The amplifier is capable of operating from sources
supplying a wide range of input levels. The Level
control should initially be set to the mid-rotation posi-
tion. If it is found that there is not enough output even
when the volume control on the car stereo is at its
maximum setting, adjust the Level control to increase
2
HIGH LEVEL GAIN
MIN MAX
FUSE
the output from the system. If, however, there is still
output from the amplifier when the car stereo volume
control is at its minimum setting, or the output level
increases too fast with a small rotation of the volume
control, adjust the Level control to decrease the output
from the system. Once the correct setting is found, this
control should not require any further adjustment.
3
Fuse
The circuitry of the amplifier is protected from damage by
an automotive-type fast-blow fuse. If fuse replacement is
necessary, use only fuses of the same ampere rating as
originally supplied with the unit. The use of fuses with
incorrect ratings may cause serious damage to the
amplifier. If fuses blow consistently, carefully check all
electrical connections to the unit.
-8-
3
POWER
SPEAKER OUTPUT
BATT
REM
GND
LEFT
LEFT
RIGHT
RIGHT
Hide quick links:
Advertisement
