Test Facility - Allied Telesis AT-AR020 PRI E1/T1 Hardware Reference Manual

Port interface card
Hide thumbs Also See for AT-AR020 PRI E1/T1:
Table of Contents

Advertisement

44
Figure 34: Example output from the show test command
Board
ID
Bay Board Name
----------------------------------------------------------------------------
Base
62
IC Module
38
0
IC Module
44
1
MAC
68
Interface
State
----------------------------------------------------------------------------
eth0
halted
port0
complete
port1
complete
syn0
testing
PRI0
halted
mac0
complete
mac1
complete
mac2
complete
----------------------------------------------------------------------------

Test Facility

The Test Facility is designed to test physical interfaces on all PICs except the
AT-AR026. Testing can be performed while the switch or router is operational,
but any interfaces being tested are dedicated to the Test Facility. The Test
Facility can be thought of as a specialised interface module like PPP or Frame
Relay.
AT-AR026 PICs do not support the Allied Ware Diagnostic or Test Facility modules.
The Test Facility is built into all switch and router software. For more
information on the Test Facility's operation, see the Test Facility chapter of the
Software Reference.
Allied Telesyn PICs support a wide range of interface types, including
Ethernet, asynchronous, synchronous, Basic Rate ISDN and Primary Rate
ISDN. Each interface type can be tested independently using the Test Facility
software. The following examples show how to test specific interfaces.
Test results are displayed with the command:
show test
which produces a display like that shown in
AR720
AR023 PIC Sync
AR025 PIC E1 PRI
AR011 ECMAC
Result
* Active LAN
good
good
wait continuous
good
good
good
Figure
Rev
Serial number
M1-0
6845181
M1-1
5917086
M1-0
6843626
P1-1
6804365
Duration
Type
(minutes)
Data( %OK )
trans
< 1
BAD (
TP
0
-
ENDEC
0
-
MAC
0
-
-
1000
good( 99.0)
-
1000
good( 99.0)
RS-232dte
355
good(100.0)
dce
355
good(100.0)
X.21
dte
354
good(100.0)
dce
0
-
V.35
dte
354
good(100.0)
dce
0
-
-
< 1
BAD (
DES
4
good(100.0)
STAC
4
good(100.0)
ALL
4
good(100.0)
Port Interface Card
34.
Details
Control
0.0)
-
-
-
-
-
-
-
good
good
good
good
good .
-
-
good
-
-
0.0)
-
-
-
-
C613-03023-00 REV J

Advertisement

Table of Contents
loading

This manual is also suitable for:

At-ar021 (s) bri-s/tAt-ar021 (u) bri-uAt-ar022 ethAt-ar023 synAt-ar024 asyn4At-ar026 4eth ... Show all

Table of Contents