16
Notes for
Table 9 on page
1. Up = 10kΩ link between pads 1 and 2.
2. Down = 1kΩ link between pads 2 and 3
3. Floating = no link
4. Requires auto-negotiation on port 1 to be disabled (using link MCOL).
5. Requires auto-negotiation on port 2 to be disabled (using link MRXD 0).
6. Requires auto-negotiation on port 3 to be disabled (using link MRXD 1).
7. Requires auto-negotiation on port 4 to be disabled (using link MRXD 2).
Links 22, 31, 40, and MRXD 3 are fixed and should not be changed. Attempting
to change these links will cause the PIC to cease functioning.
AT-AR027 VoIP-FXS PIC
The AT-AR027 VoIP-FXS PIC provides two Foreign Exchange Subscriber (FXS)
ports. The ports use RJ-11 connectors and can be connected to standard analog
telephony equipment such as telephones, fax machines and modems. The FXS
interface supplies ring, voltage and dial tone.
The AT-AR027 VoIP-FXS PIC is shown in
are listed in
Table 10 on page
Figure 12: AT-AR027 VoIP-FXS PIC
OFF HOOK
PIC REG
AT-AR027 features include:
•
Settable ring wave form
•
Settable tone generation
•
Settable port gain/attenuation for transmit and receive on each port
•
600r, 600c, 900c, Cplx and Cplx2 port impedance.
•
Frame buffer management
•
Voice activation and silence detection
•
Compatible with H.233, Session Initiation Protocol (SIP) and Media
Gateway Control Protocol (MGCP)
When using AT-AR027 PICs with an AR740 router and NSM, a maximum of
four AT-AR027 PICs can be installed in the router and NSM.
More information on protocols and how to configure them on the PIC can be
found in the Software Reference for your switch or router.
15.
Figure
17.
Two FXS VoIP Ports
(RJ-11 connectors)
1
/RING
Four LEDs
Port Interface Card
12, and functions of the LEDs
0
OFF HOOK
/RING
PIC ERROR
C613-03023-00 REV J
AR027PIC