10
AT-AR022 ETH PIC
The AT-AR022 ETH PIC provides a dual Ethernet 10BASE-T/AUI port. Only
one interface type can be active at any one time and the PIC automatically
senses which interface is in use. The 10BASE-T interface uses an RJ-45
connector and the AUI interface uses a DB15 connector.
AT-AR022 ETH PICs are not recommended for use in AT-AR040 NSM PIC
bays because performance of these interfaces is likely to be reduced and packet
loss may occur.
The AT-AR022 ETH PIC is shown in
listed in
Table
6.
Figure 6: AT-AR022 ETH PIC
Ethernet 10BASET port
(RJ45 connector)
Table 6: AT-AR022 ETH PIC LED functions
LED
Function
Link
Lit when the Ethernet interface is connected to a device (e.g. a hub) which is
generating link pulses.
Data
Lit when data is being transmitted or received over the Ethernet interface.
The AT-AR022 PIC is a single card.
Figure
6, and the functions of the LEDs are
Ethernet AUI port
(DB15 connector)
LEDs
Figure 7
shows the layout of the board.
Port Interface Card
PIETH1R
C613-03023-00 REV J