Advertisement
1) choose the recordable channel by
Radio
8101-5
pressing short the CH button. The channels
are switched circle-wise each time you
press;
2) record the channel by pressing short the
"STOP" button.
Radio
Press short the programming button.
8152-50
3. Delete the remote control channel from the memory of the device (PM of remote
controls)
Radio
a) in dynamic mode:
1) input the remote control in programming
8101-1M
mode: press the button 3 times in a row, and
hold it for more than 4 sec. when pressing
for the fourth time. The pressing interval
should not exceed 1 sec.;
2) delete the remote control: press and hold
the remote control button for more than
1 sec.
b) in static mode: press and hold the remote
control button for more than 1 sec.
Radio
a) in dynamic mode: press and hold the
8101-2M
button of erasable channel, and press any
8101-4M
other for more than 1 sec.;
b) in static mode: press and hold the button
of erasable channel for more than 1 sec.
1) choose the erasable channel by pressing
Radio
8101-5
short the CH button. The channels are
switched circle-wise each time you press;
2) delete the selected channel: press and
hold the "STOP" button for more than 1sec.
Radio
Press and hold the programming button for
8152-50
more than 1 sec.
4. Delete channels of all remote controls from the memory of the device (PM of
remote controls)
Press and hold the programming button for more than
4 sec.
5. Output the device from the PM of remote controls
Press short the programming button.
The device is automatically removed from the programming mode, if no
actions are performed with it during 32 sec.
6. Operation modes
The device has 4 operation modes:
Short command mode is used to connect the external automatics (fig. 2 and fig. 3). Command
time is 1,5 sec.
Roller shutter mode is used to control electric drives of roller shutters, roller blinds, sun
If the memory is full, the
blinds. Command time can be installed up to 180 sec. Factory setting is 60 sec. (fig. 1).
indicator blinks yellow for
Roller shutter mode with auto closing is used to control roller gates. Auto closing time can
3 sec.
be installed up to 240 sec. Factory setting is 20 sec.
Continuous command mode is used to control lightning and another load up to 3 A/690 W.
It is recommended to connect incandescent lamps not more than 220 W.
The command and auto closing time settings allow you to optimize the control of the roller
shutters. The command time is set in accordance with the size of the roller shutter curtain. The
auto closing timer is set according to the required waiting time for closing in the open position.
The visual indicator of the
Auto closing timer is turned on after:
remote control blinks red in
a) the time expiration of the "UP" command;
programming mode.
b) the stopping in an intermediate position upon a command from a remote control or a key
switch;
When deleting the visual
c) the unlocking the device using a safety sensor.
indicator will flash long-
term and then will continue
to blink red.
The visual indicator will
flash long-term and then
will continue to blink red.
Power supply
220-230 V~
The visual indicator will
Fig. 2 Connection to step-by-
flash red for a long time
twice.
The visual indication stops.
Gate and
barrier control
unit
Gate and barrier
control unit
To delete
To install
the jumper
the jumper
step input
Power supply
220-230 V~
jumper
Fig. 3 Connection to separate
"OPEN" and "CLOSE" inputs
To
delete
the
Advertisement
