Advertisement
Connecting an AC Power Cord
To connect an AC power cord to a CSS 11800:
1.
Ensure that the CSS power switch is in the 0 (off) position.
2.
Attach the power cord to the CSS by plugging the AC power cord connector into the power receptacle at the front of
the chassis as shown in the illustration below.
PS1
PS2
3.
Plug the power cord into a dedicated 3-wire grounding receptacle.
4.
Switch on the power on the CSS.
Removing a Power Supply
To remove a power supply:
1.
If necessary, power down the CSS (if no redundant power supply is installed).
2.
Loosen the captive panel fasteners on the power supply front panel.
3.
Grasp the power supply handle and carefully pull the power supply out of the chassis.
May 2002
PS2 AC Power Cord
PS1 Power Switch
PS2 Power Switch
PS1 AC Power Cord
Document Number: 78-11505-01
Advertisement
