Drive Installation; Drive Slot Numbering; Controller Installation - D-Link DSN-6200 Series Quick Installation Manual

Drive Installation

Note : Skip this section if you purchased a solution already
installed with hard drives.
SAS or SATA with no Bridge Board
To install SAS or SATA drives with no
Bridge Board use the front mounting
holes.
SATA drives with Bridge Board
To install SATA drives with Bridge
Board (DSN-654), fit the Bridge
Board first.
Then install the drive using the rear
mounting holes.
Remove the drive tray and install the HDD. To install SAS
drives, align the edge of the SAS drive to the back end
of the tray; the backplane can directly connect to SAS
drives. To install SATA drives with 6 Gb MUX boards, align
the 6 Gb MUX board edge to the back end of tray; the
backplane can connect SATA drives through 6 Gb.

Drive Slot Numbering

Slot 1 Slot 4 Slot 7
Slot 2 Slot 5 Slot 8
Slot 3 Slot 6 Slot 9
Hard drives can be installed into any slot in the enclosure.
The slot numbering above will be reflected in the web UI.
PSU2
Install Battery Backup Module
Please follow the procedure below to install the battery
backup module.
Slot 10
Slot 11
Slot 12
Latch
D-Link DSN-6200/6500 Series Quick Installation Guide
1. Ensure the DSN-6200/6500 Series is powered off.
2. The BBM module is located inside the right PSU
(PSU2 module). Release the PSU2 latch and flip the
DSN-6200/6500 Series to the back side.
3. Release the screws .
1
4. Insert the Battery Backup Module (BBM).
5. Place the BBM back in the PSU, and secure the
bracket with screws.

Controller Installation

The please follow the procedure below to install the
battery backup module.
1. Ensure the DSN-6200/6500 Series is powered off.
2. If you purchased the DSN-6200/6500 Series without
a second controller (for redundancy). Install the
controller as pictured below .
1
3