Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for NewLine TradePro Curved
Summary of Contents for NewLine TradePro Curved
- Page 1 1. When you receive your Newline shower check contents for any freight damage. 2. Advise Newline on 0508 639 5463 if any damage has occurred or a defect 3. Do not install any faulty product as this will invalidate later claims.
-
Page 2: Warranty
DOOR SET / IMPORTANT INFORMATION WARRANTY Faulty goods are covered under warranty. Visit www.newline.co.nz for warranty information. Breakages incurred during construction are not covered under warranty. Installations must conform to the instructions to be covered by the warranty. HEALTH AND SAFETY Toughened Glass: •... -
Page 3: Assembly Diagram
ASSEMBLY DIAGRAM Before commencing installation, please ensure you have the following components in your package to complete installation. [14] REF DESCRIPTION PART NO. QTY REF DESCRIPTION PART NO. Screws M3.5x35 Bump stop caps PAR6848 Wall plug (concrete) Door panels SCREW PACK PAR7296 Screw cap covers Top rollers... -
Page 4: Layout Plan
LAYOUT PLAN 13mm IMPORTANT: Position the wall channels at 13mm off the Acrylic tray edge (Diagram A). This will allow for walls out of plumb protruding or curving inwards up to 4mm. Greater variations to plumb will require recalculated reduction of Diagram A. INSTALLATION STEPS PAGE 5 TO 8 MINIMUM AND MAXIMUM TABLE The Minimum and Maximum table is intended for shower installations outside of the package... -
Page 5: Installation
INSTALLATION Using a soft pencil or masking tape mark out the outside boundary line on the base and up the walls with a spirit level. Use the wall channel holes to pre-drill a 2mm lead hole in the lining. Apply a continuous 7mm bead of silicone on back of channel plus short bead across tray to liner join at base of channel. - Page 6 INSTALLATION Fit the frame into the wall channels. VIEW FROM INSIDE Fit the door assemblies as illustrated. Adjustment the bottom roller to enter or remove from bottom rail. Detailing of shower assembly: • A1 and A2: Fit the Door handles •...
- Page 7 INSTALLATION Adjust the sliding doors as shown in the illustration below. ADJUST THE SLIDING DOORS USING THE SCREWS LOCATED ON THE BOTTOM OF TOP ROLLER ASSEMBLIES. ADJUST ROLLERS SO THAT THE SLIDING DOORS ARE PARALLEL TO EACH OTHER. NOTE: DO NOT OVER TIGHTEN TOP ROLLERS AS THIS WILL CAUSE THE BOTTOM ROLLERS TO JAM AND BREAK A.
- Page 8 SCREENS THAT ARE SEALED ON THE INSIDE WILL VOID WARRANTY. CONTACT Freephone: 0508 639 5463 Phone: 09 444 2053 Fax: 09 443 0044 Email: info@newline.co.nz www.newline.co.nz...
Need help?
Do you have a question about the TradePro Curved and is the answer not in the manual?
Questions and answers