Advertisement
P1
P3
Internal Cable Installation
1. Referring to Figure No. 4, locate the Analog Output connector P2
on the main board.
2. Plug the analog output cable 3 pin connector into the main board
P2 connector, making sure the polarizing tab is correctly aligned.
3. Locate the Analog Output terminal block P2 on the 2XX-DAC
board. See Figure No. 5.
4. Connect each wire of the analog output cable to terminal block P2
on the 2XX-DAC board, referring to the labels on both the main
board and the 2XX-DAC board for correct terminal connections.
5. To terminate a wire, press down on the terminal release bar. Insert
the wire into the terminal opening then release the bar, locking the
wire in place. Repeat the procedure until all wires are in place.
P2 on Main Board and 2XX-DAC P2 Terminal Block
PIN ID
COM
0-10V
4-20 mA
Re-Assemble the Indicator
1. With one hand, lift the keypad ribbon cable up out of the
enclosure and hold out of the way.
2. Align the front edge (display end) of the main board assembly
with the second slot (from the bottom) on both sides of the
enclosure. See Figure No. 6.
3. Slide the main board assembly into the enclosure
approximately 1 inch.
4. Attach the keypad ribbon cable to P6, and then slide the main
board assembly into the enclosure until the rear panel meets
the back edge of the enclosure. See Figure No. 7.
INSTALLATION, CONT.
MODEL 200
ANALOG OUTPUT CABLE
P2
THREADED STUD
Figure No. 4
ANALOG OUTPUT CONNECTIONS
Function
Common
0 to 10 volt output (2K Ω Min. Load)
4 to 20 mA current output (500 Ω Max. Load)
8200-M350-O1 Rev B • 2XX-DAC
MAIN BOARD P2
P2
Figure No. 5
Figure No. 6
ALIGN HERE
P1
5
Advertisement
