Advertisement
MODELS 205/210/215, 220 AND 225
Cable Installation
1. Loosen a cable gland connector for the Analog
Output cable.
2. Slip a two wire cable through the gland connector
and into enclosure.
3. Remove 2" of outer insulation jacket then remove
1/4" of insulation from each of wires.
4. Connect each of the wires to terminal block (P2).
5. To terminate, first press down on the terminal release
bar and then insert the wire into opening. Allow the
release bar to return to its original position, locking
the wire in place. Repeat the procedure until all
wires are in place.
Re-Installing the Rear Panel
After all terminations have been made, remove the excess cable from the instrument enclosure
and securely tighten each of the cable gland connectors. Do not over-tighten these connectors
but make certain they are snug. DO NOT USE TOOLS! Finger tighten only! Insure any
unused gland connectors are plugged.
1. Make certain no cables or wires are exposed between the main housing and rear panel and
then place the rear panel onto the main housing.
2. Secure with the acorn nuts (12 on the 205/210/215, 14 on the 220 and 225) removed
earlier. Follow a diagonal pattern when tightening the acorn nuts.
3. On the 205/210, if using the optional battery,
A. Insure the ( - ) negative polarity markings of the battery are positioned facing up
(towards the front of the indicator) and the alignment notch in the battery is to the left.
B. Slide the battery into the opening, compressing the battery ejector spring, until you feel
resistance and the battery is almost flush with the bottom of the indicator.
C. Replace the Battery Access Cover and install the three acorn nuts removed earlier,
securing the battery in place.
4
On the Model 215,
A. Turn the battery tray so that the batteries (or empty battery holder) are facing the rear
of the indicator and place the battery tray in the opening.
B. Slide the battery tray into the opening, aligning the holes in the battery tray with the
threaded studs on the bottom of the indicator.
C. Install the three acorn nuts removed earlier, securing the battery tray in place.
IMPORTANT
be installed for the indicator to function.
5. If required, install the lead and wire calibration seal.
INSTALLATION, CONT.
! On the Model 215, the battery tray (with or without batteries) must
8200-M350-O1 Rev B • 2XX-DAC
PIN NO.
Function
COM
Common
0 to 10 volt output
0-10V
(2K Ω Min. Load)
4 to 20 mA
4-20 mA
current output
(500 Ω Max. Load)
P2 TERMINAL BLOCK
3
Advertisement
