Advertisement
CALIBRATION OF ANALOG OUTPUT, CONT.
Adj Lo
This sets the DAC output to zero for adjusting the level. Adjustment "pots" (10V and 4 mA) on
the option board are used.
• There is no adjustment for zero volts out.
• For 4 to 20 mA current output, adjust the 4mA pot for the low (4 mA) current output.
Press the ASTERISK key to return to the Adj Hi prompt or press the ENTER key to proceed
to the gdac prompt.
NOTE! Cycling between
the current out. This must be repeated until no adjustment is necessary.
Gdac=
This sets the DAC output to follow the Gross weight only or the displayed weight (gross or net).
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it and return to the SetUP prompt.
Otherwise, using the numeric keys, 0/NO or 1/YES, enter the new setting, then press the
ENTER key to save it and return to the SetUP prompt.
Gdac= YES
DAC output is Gross Weight Only
8
MODELS 200/205/210/215
Adj Hi
and
Gdac= no
8200-M350-O1 Rev B • 2XX-DAC
Adj Lo
is necessary when adjusting
DAC output is the displayed Weight
(gross or net)
Advertisement
