Advertisement
CALIBRATION OF ANALOG OUTPUT, CONT.
ADJ HIIGH
This sets the analog output to VOLTS OUT= level for adjusting the level. Adjustment
potentiometers "pots" (10V and 20 mA) on the option board are used.
• Adjust the 10V pot for the maximum voltage output entered for VOLTS OUT=.
• If the 4 to 20 mA current output is to be used, adjust the 20mA pot for the calculated
maximum current.
Press the ENTER key to proceed to the ADJ LOW prompt, or the ASTERISK key to return to the
previous prompt.
ADJ LOW
This sets the analog output to zero for adjusting the level. Adjustment "pots" (10V and 4 mA)
on the option board are used.
• There is no adjustment for zero volts out.
• If the 4 to 20 mA current output is to be used, adjust the 4mA pot for the low (4 mA)
current output.
Press the ASTERISK key to return to the ADJ HIGH prompt, or the ENTER key to return to the
SETUP prompt
NOTE! Cycling between ADJ HIGH and ADJ LOW is necessary when adjusting the
current out. This must be repeated until no adjustment is necessary.
10
MODEL 220
8200-M350-O1 Rev B • 2XX-DAC
Advertisement
