Required Tools - Ryobi RM480e Original Instructions Manual

ASSEMBLY SAFETY RULES
WARNING
To reduce the risk of injury, read and
understand the assembly section of this
manual before attempting to assemble the
product. Save this guide for future reference.
WARNING
Strictly adhere to all torque wrench
tightening specifications. Failure to do so
could cause serious personal injury.
All information, illustrations, photographs,
and specifications contained in this manual
are based on the latest product information
available at the time of publication. Due to
improvements or other changes, there may
be some discrepancies in this manual. We
reserve the right to make product changes at
any time, without notice and without incurring
any obligation to make the same or similar
changes to any products previously built or
sold.
■ Any person attempting to assemble the
product must have proper training and
experience. Read this manual carefully
and follow all assembly procedures in this
manual.
■ All assembly must be completed with the
product on a level surface.

REQUIRED TOOLS

The following tools are needed for assembly:
■ Torque wrench
■ Tyre pressure gauge
■ Socket wrench
● 12 mm socket
● 14 mm socket
● 6 mm hex bit
12
UNPACKING
■ Remove the bolts securing the corner and
side braces to the bottom frame, then lift
the braces to remove them.
■ Cut the nylon straps securing the front and
rear wheel axles to the frame.
■ Remove the boxes containing loose parts,
assembly hardware, and documentation.
■ Remove and set aside all accessible
packaging and wrap from the unit and
parts. Do not discard the packing material
until you have carefully inspected and
satisfactorily operated the product.
WARNING
If any parts on the "Loose parts list" section
are already assembled to the product
when you unpack it, verify the part is
assembled correctly, is properly tightened,
and is torqued correctly (where applicable)
before proceeding to the next assembly
step. The use of a product that may have
been improperly assembled could result in
serious personal injury.
■ Inspect the product carefully to ensure that
no breakage or damage occurred during
shipping.
■ If any parts are damaged or missing,
contact an authorised service centre.
NOTE: The product should be assembled
while positioned on the bottom frame.
Once assembly is complete, raise the
cutting deck to its maximum height, then
position a ramp next to the bottome frame,
and slowly and carefully drive the product
off the frame.