Advertisement
Cable Management for Units with 200mm to 600mm Travel
The rear of the projector mounting plate has a cable management access hole that allows
you to run cables through and into the cable management channel.
Lay out the required cables and lock them into position utilising cable ties in the small
regular holes running up the channel.
Be sure to allow enough slack in the cables at every hinged elbow point so the cables don't
interfere with the travel of the lifter.
Exit cables through the supplied opening on top of the unit.
Cable Management for Units over 600mm Travel
On units with longer travel a second type of cable management is required.
Above the projector mounting position is an access hole for the cables and various cable tie
mounting holes, please see the picture below this text.
This allows the cables to run up the centrally mounted cable run planes, to the mid section
of the plane, where the cable tie holes cease.
This is the point where you stop and run to the front of the upper cable run plane, leaving
enough slack in the installation for so cables don't pinch or stretch.
Control
Connect Control Module – Standard
After the installation of the Interfit Projector Lift is completed, plug into a standard power point and turn on.
The AV Lift can be operated in three ways:
2 Channel Infra Red Remote Control ‐ supplied
Impulse wall Switch – Up & Down (supplied by others)
Dry Contact Closure – SPDT (Single Pole Double Throw), for control system connection.
Advertisement
