Table of Contents
Advertisement
Microsoft Windows XP:
1. Insert the adapter. Windows XP will detect the adapter and start the Found New
Hardware Wizard.
2. Insert the Wireless Adapter Driver disk and select "Install from a list or specific location
(Advanced)"; then choose
3. Check "Include this location in the search" and type the following into the location box:
e:\Vigor520\winxp
4. Choose
. Installation will begin.
Next
5. When the Found New Hardware Wizard indicates that installation is complete, choose
.
Finish
After the driver is installed, an icon of a CardBus adapter will appear in the "system tray" or
"notification area" of the task bar. The following illustration is from Microsoft Windows 98; the
corresponding portion of your screen may look quite different:
Figure 6. Driver icon in system tray/notification area
4.3 Controlling the Driver
The driver normally works automatically:
•
When the computer is turned on with the adapter inserted, the driver is loaded and its
icon appears in the "system tray" (also called the "notification area").
•
When the computer is turned on with the adapter removed, the driver is not loaded and its
icon does not appear.
You can also control the driver and the adapter as follows:
•
To deactivate the driver: Click the driver's icon using the mouse's main button
(usually the left button) and choose
This will unload the driver from the computer's memory and turn off power to the
adapter. The message "You may safely remove this device" will appear; choose
continue.
.
Next
Stop TI ACX100 WLAN Adapter
Figure 7. Driver icon menus (1): main button
10
.
to
OK
Advertisement
Table of Contents
