Table of Contents
Advertisement
2
Safety
2.1 Safety measures
2.2 Wearing parts
Filling adapters are used for the filling of self-sufficient nitrogen cylinders in order to adapt the various
connecting threads.
These filling adapters are particularly prone to wear and other specific stresses if the correct filling process
is not adhered to. As such issues cannot be ruled out, the filling adapters must be checked for damage
before each filling process.
Furthermore, these adapters, as well as the M8 standard nipples fitted in the base body, must always be
replaced after 100 filling processes or in the event of damage.
Other components of the control set must be checked regularly for wear or damage, and replaced if so
required.
Non-observance may void the guarantee or warranty. In addition, STEINEL Normalien AG is not
liable for damage caused by improperly maintained/replaced materials!
2.3 Danger from hidden hazards/remaining risks
Version 05.2020
The following notices serve to recognise and avoid dangers in order to
ensure a handling of the control set that is as safe as possible when using it.
Read and observe all notices and commands within these operating instructions.
Non-observance of safety instructions and commands can result in very serious
injury.
Keep the operating instructions in a safe place and supply them to the operator.
When working with the control set, severe and unpredictable remaining
risks generally exist and can only be counteracted with systematic work
planning, working with an awareness of dangers, experience, etc.!
The following list is meant to bring some of these dangers to your attention.
If the filling adapters or M8 standard nipples are subjected to lateral,
impact or bending loads, the adapters may become damaged and
malfunction.
Be sure to wear appropriate personal protective equipment for all tasks!
Therefore perform all tasks with the utmost diligence!
Operating instructions for the SZ8085 control set
WARNING
9
Advertisement
Table of Contents
