Table of Contents
Advertisement
2
Safety
2.4 Application
The STEINEL control set is used for filling, the variable pressure setting of and for checking the gas pres-
sure in various nitrogen systems.
ƒ Self-sufficient nitrogen cylinders
ƒ Tube connected nitrogen cylinders*
ƒ Composite plates*
ƒ Manifold plates*
* As long as the controls are readily accessible, it is possible with these systems to adjust the pressure while they are in operation.
2.5 Authorised personnel
Only specialist personnel trained by the STEINEL Normalien AG in the handling of nitrogen systems (expert,
commissioned and trained personnel) may fill the nitrogen systems.
Learn more about STEINEL Normalien AG's training opportunities. "Trained expert personnel" refers to
persons that, based on their training, experience and manufacturer training, as well as their knowledge
of relevant standards, can evaluate the tasks assigned to them and recognise potential dangers.
These persons must be authorised (by the person in charge of the safety of the device) and able to perform
the respectively required tasks and to recognise and avoid potential dangers while doing so.
10
Danger of injury due to improper operation of nitrogen systems!
Before the nitrogen systems are filled, their safe condition with regard
to accidents and operation is to be checked by suitably qualified
personnel.
The nitrogen systems may only be operated by expert, authorised
and appropriately trained personnel.
Operating instructions for the SZ8085 control set
WARNING
Version 05.2020
Advertisement
Table of Contents
