Warranty And Liability - STEINEL SZ8085 Operating Instructions Manual

1 Introduction
ƒ Always wear personal protective equipment as described in the relevant safety instructions when
working with the control set. Working with the control set without personal protective equipment is
not permitted.
ƒ Wear the appropriate protective clothing corresponding to the work that needs to be performed!
ƒ Do not wear long hair open, loose-fitting clothing or jewellery!
ƒ Only perform those tasks for which you have been sufficiently trained and instructed!
ƒ When a safety threat occurs, immediately disconnect the control set from the power supply,
prevent it from starting again and notify the supervisor in charge and/or the safety representative
right away!
ƒ Do not carry out any constructional changes without the expressed written consent of the
manufacturer!
ƒ Make sure that persons who do not work with the control set (and therefore do not know the
remaining risks associated with the control set) cannot enter the danger area.
1.5 Warranty and liability
For the use of the control set, our "General Terms and Conditions" always apply.
The "General Terms and Conditions" are accessible via our homepage.
Warranty or liability claims in case of damage to persons or property are precluded if they were the result
of one or several of the following causes:
ƒ handling in a non-intended manner
ƒ improper assembly, commissioning, operation, maintenance and inspection
ƒ non-observance of the notes contained in these operating instructions regarding safety, putting into
service, operation, maintenance and inspection
ƒ unauthorised structural alterations
ƒ insufficient monitoring and maintenance
ƒ external elements or force majeure
ƒ performance of maintenance work (repairs)
In order to maintain functional reliability, only original spare parts, tools and appliances of the manufac-
turer may be used.
6 Operating instructions for the SZ8085 control set Version 05.2020