Care And Cleaning Instructions; Pad Replacement - Prestan AED UltraTrainer Instructions Manual

CARE AND CLEANING INSTRUCTIONS

1. Store the Prestan AED UltraTrainer in its case and in a cool, dry area.
2. Return the training pads and cables to their respective storage pouches located on the interior lid
of the unit's cover. If pads and cables are stacked on top of the unit, the cables may imprint
grooves/indentations into the surface of the pads.
3. If the unit is being stored for long periods, remove batteries to protect against corrosion.
4. Never pick up or carry the unit by the cables.
5. The Prestan AED UltraTrainer should be kept clean. If it becomes soiled, simply wipe with a clean,
damp, soft cloth. If the Trainer is extremely dirty, common cleaners can be used cautiously with a
minimum amount of abrasion to ensure the life of the unit. Do not submerge unit in water.
1. Prestan Training Pads will generally last approximately 100 uses.
2. When pad replacement is needed, it is good practice to replace both pads at the same time.
3. Release the existing pads from the gray cable connectors by popping
out the black pad connector pins with the tip of a ball point pen.
4. Slide the pads out from the cable connectors.
5. Insert new pads into the cable connectors.
6. Use the pad connector pins to lock the pads in place.
▪ Insert pad into cable connector (be sure the pad graphics are on same side as the large head
of the connector pin and that the connector pin snugly fits into the indentation in the cable
connector)
C P
ONNECTOR
C C
ABLE ONNECTOR
▪ Insure pad is not upside down
▪ If the pad has a protective backing
over the adhesive (replacement pads),
remove and dispose of this and adhere
the pads to the double-sided pad case
COPYRIGHT© 2020 PRESTAN PRODUCTS, LLC

PAD REPLACEMENT

IN
8
U D
PSIDE OWN