Page 1
1814 S / ARC QUICK REFERENCE GUIDE The quick reference guide is not a substitute for the Operators Manual! Please refer to Operators Manual for more detailed information TRACTOR CONNECTION (ARC) 1. Hydraulics Red pipe > Supply (50 lpm) Blue pipe >...
Page 2
OPERATION Start the engine to activate the hydraulic system (S model only). Place a bale on the wrapping table. With the controller set to “Auto Mode”, press “Auto Start” on the remote (a) or on the controller (b). The wrapping cycle will then begin.
Page 3
EXPERT CONTROLLER OPERATION - Current No. of wraps 4-way Menu switch: - Target No. of wraps Set no. Of wraps - Wrapping speed (RPM) Change/Reset Bale Sub-Total - Bale total Access Operator Setup Menu - Grand total No. of bales Access Technician Setup Menu - Mode: Manual /Auto Pause wrapping (A)
Page 4
AUXILIARY CONTROL VALVES Used for lowering the machine to the ground in preparation for wrapping. Used for adjusting hydraulic jack at drawbar. This is necessary for levelling the machine prior to wrapping. Used for adjusting the width of the rocking rollers when changing to different size bales.