Table of Contents
Advertisement
8. Grasp the PSU handle latch between the thumb and forefinger and press the latch tab down to unlock the handle.
Revolve the handle out and downward to lever the PSU out of the enclosure as shown in
Figure 70 Removing a PSU (1 of 2)
9. Grip the handle and withdraw the PSU, taking care to support the base of the module with both hands as you remove
it from the enclosure as shown in
Figure 71 Removing a PSU (2 of 2)
10. If you are replacing two PSUs, repeat steps 5 through step 8, being mindful of the illustrations TIP on
Installing a PSU module
See
Figure 70 (page 92)
arrows—since you will insert the module into the slot—rather than remove it.
IMPORTANT: Handle the PSU carefully, and avoid damaging the connector pins. Do not install the PSU if any pins
appear to be bent.
1. Check for damage, especially to all module connectors.
92
Module removal and replacement
Figure
71.
and
Figure 71 (page 92)
when performing this procedure, but ignore the directional
Figure
70.
page
90.
Advertisement
Table of Contents
Troubleshooting
