Attaching Inner Rails To The Storage Enclosure - Seagate Exos AP 4U100 Installation And Maintenance Manual

Attaching inner rails to the storage enclosure

You must correctly attach the inner rails to the storage enclosure to bear the weight of its contents.
Required equipment
Inner rails, properly oriented
T10 Torx torque driver, 6-in. length
M3 low profile screws, 5x2.75-in. length
#2 Phillips-head screwdriver, 6-in. length
Panhead screw, M4x4mm length
CMA A bracket
To attach inner rails to the storage enclosure:
1. Examine the inner rails, locating the smooth inner edge of the rail, the flanged outer edge, and the top notch at the
rear of each.
Figure 43 Left and right inner rail edge details
2. Orient the left inner rail so that the flat face at the front of the rail is to your right, the top notch is to your left, and the
smooth inner edge away from you.
3. Face the left sidewall of the storage enclosure, then align the left inner rail's key holes to the six pairs of sidewall
Tpins.
Quantity Identification
2 N/A
1 N/A
10
1 N/A
2
1
Preparing for installation 61