Table of Contents
Advertisement
Features and Functions
Actions
To power ON or OFF
To enable data hold function
To trigger holding next reading
To exit data hold mode
To enable recording function
• The beeper will beep when a new MAX or MIN value has
been recorded.
• The static recording captures stable values and updates
the memory. It will not record values that are overloaded,
OL or below 10 count value.
To cycle through maximum, minimum, average, and present
readings
• MAX, MIN, AVG or MAX AVG MIN annunciator will be
turned on respectively to indicate which value is being
displayed
To exit the recording mode
To enable relative function
• Relative function shows the difference between the
measured value and the offset reference value. The
display may show a non-zero value due to the presence
of test leads. Use the relative function to nullify the
residual.
• Relative function can operate in both auto and manual
ranging mode but the function cannot be set when an
overload value exists.
• REL annuciator will be displayed.
To renew the relative value
To exit relative mode
To select manual range and to turn off the AUTO
annunciator
To step up a range at a time
5
Steps
Press
Press
Press
momentarily
Press
for more than 1 s
Press
Press
momentarily
Press
for more than 1 s
Press
Press
again
Press
for more than 1 s
Press
Press
again
U1701A Quick Start Guide
Advertisement
Table of Contents
