Portable Hydrographic Work Station Description; Ethernet Switch Description; Remote Control Unit (K-Rem) Description - Kongsberg EM 2040 Installation Manual

KONGSBERG EM 2040 Installation

Portable Hydrographic Work Station description

The Hydrographic Work Station is the operator station of the EM 2040.
A dedicated maritime computer is provided with
the EM 2040 Processing Unit. It is set up with all
necessary software.
The Hydrographic Work Station is available in a semi
rugged or fully rugged version for portable use.

Ethernet switch description

A high capacity Ethernet switch may be required.
If you use more than one Processing Unit, a high capacity Ethernet switch is required.
The Ethernet switch is used to connect each Processing Unit to the Hydrographic Work
Station. A high capacity Ethernet switch is included in the EM 2040 delivery.
Note
It is very important that a high-quality Ethernet cable is used. You must use CAT-5E
quality or better. If you use cables with lower bandwidth capacity you will reduce the
EM 2040 performance.
1000BASE-T (also known as IEEE 802.3ab) is a standard for gigabit Ethernet over
copper wiring. Each 1000BASE-T network segment can be a maximum length
of 100 meters (330 feet), and must use Category 5 cable or better (including Cat
5e and Cat 6).
https://en.wikipedia.org/wiki/Gigabit_Ethernet

Remote Control Unit (K-Rem) description

A dedicated junction box has been designed to provide remote on/off switches with light
indication and interface to a remote synchronizing system. The junction box contains a
terminal block and four switches with lamps mounted in the front.
Note
The Remote Control Unit is not a standard part of
the EM 2040 delivery.
The Remote Control Unit is called K-Rem. It is
prepared for remote control and interface to an external
synchronization system for four KONGSBERG echo sounders.
14
(January 2016)
391932/D