Gudsen MOZA AirCross 2 Release Notes

Date
Firmware
What's New?
Fully optimized algorithm for the stability control.

Fully optimized parameters algorithm for Auto-Tuning to further improve the motor performance.

Optimized battery power display under low voltage conditions.

Added language selection option when power on for the first time.

Added the prompt box "please manually check and balance the P axis!" before exiting the

balance check function.
Added the left side calibration function for roll axis when the camra is mounted on the left side.

The AirCross 2 will not be automatically re-centered when the upright mode is switched to under

slung mode.
Solved the problem of the AirCross 2's abnormal rotation in the hand wheel control mode.

Notes:
1. The right side calibration is only for when roll axis is placed on the right side of the camera while
the left side calibration is only valid when roll axis is placed on left side of the camera;
2. The gimbal will automatically return to the center when the upright mode is switched to under
slung mode in the old firmware version.

Upgrade via computer:

Turn off the AirCross 2, long press the center button, hold it and press the power button with the

other hand until the prompt 'Boot Mode' appears on the screen, then the AirCross 2 can enter
into the firmware upgrade status.
Connect the AirCross 2 to the computer with a USB Type-C cable (included with the package).

Go to Gudsen website, AirCross 2 page and download the latest MOZA Master Software, unzip

and double click (may need to give administrator access) the MOZA_Master_1.2.5, after
AirCross 2 appears on screen, click to connect the device (if AirCross 2 doesn't appear, make
MOZA AirCross 2 Release Notes
2019/9/16
V0.3.5
© 2019 GUDSEN All Rights Reserved.