Table of Contents
Advertisement
Lower Snout Cone Assembly
28
11
14
11
Snout Cone Lower Shaft Assembly
1.
Locate a second bearing assembly (Item 12 and 12.1). Install the bearing assembly onto the lower shaft with the locking
collar facing towards the snout cone flighting. Be sure to have the 2 bolt flanges on the bearing assembly.
2.
Locate Item 13, Bearing Lower Baseplate, and attach it to the previously installed bearing using 2, 5/16" x 1-1/2" carriage
bolts and regular nuts (the nuts will be used as spacers for the upcoming second bearing). Tighten the bearing to the
baseplate.
3.
Locate a third bearing assembly (Item 12 and 12.1). Install the bearing to the 2, 5/16 x 1-1/2" carriage bolts holding the first
bearing with the locking collar towards the outside of the snout cone. Tighten the bearing in place using 2, 5/16" flat
washers and nylock nuts 3/8" from the end of the shaft (see Detail E).
4.
Item 2, Nose Bearing Mount, will be needed next. Attach this bracket to the bearing lower baseplate (Item 13) using 2, 3/8"
x 1" carriage bolts, flat washers, and nylock nuts. Tighten the fasteners, but allow them so the bracket will pivot at this
point. Leave the Back Attachment Plate (Item 14) and the Nose Guard Weldment (Item 11) off the assembly at this time.
The holes in the Nose Bearing Mount will need to be accessed as template holes for attachment to the outside snout. The
lower assembly should look like the Detail E below.
5.
Repeat the assembly steps for the other Snout Cone.
DETAIL E
28
12
30
32
2
Snout Cone V2.1
12
13
2
31
29
3
35
Minden Machine Shop Inc.
1302 K Road Minden, NE
800-264-6587 / 308-832-0220
11
Advertisement
Table of Contents
