Table of Contents
Advertisement
SAFETY ALERT SYMBOL
BE ALERT! YOUR SAFETY IS INVOLVED
The Symbol Shown Above Is Used To Call Your Attention To Instructions Concerning Your Personal Safety. Watch for This
Symbol - It Points Out Important Safety Precautions. It Means ATTENTION! Become Alert! Your Personal Safety Is
Involved! Read The Message That Follows And Be Alert To The Possibility Of Personal Injury Or Death.
Read this manual before operating or working around a Snout Cone! This manual must be delivered with the equipment to its
owner and operator. Failure to read this manual and its safety instructions is a misuse of equipment.
Please, remember safety equipment provides important protection for persons around a Snout Cone that is in operation. Be
sure ALL safety shields and protective devices are installed and properly maintained. If you find any shields or guards
damaged or missing, contact Patriot Equipment for the correct items.
To ensure efficient and prompt service, please furnish us with the model and serial number of your Snout Cone in all
correspondence or other contact.
SAFETY PROCEDURES
1.
Use only lifting equipment with the proper capacity when installing or removing the Snout Cone. Forklifts with too
little capacity may tip towards the front where the lifted weight is.
2.
Do not operate unit without safety shields or guards in place. The application of the Snout Cone makes them
impossible to completely guard so extra caution needs to be given to them when working around them.
IMPORTANT: Use caution when transporting. Be alert of the transport unit's overall width when approaching
3.
obstacles, such as post sign and poles, along the road. Check the transport width of the unit to ensure clearance before
entering.
Comply with all safety warnings and cautions in this manual and in the combine operator's manuals.
4.
5.
Do not allow any riders on the corn head or near the Snout Cone when in use.
6.
In case of any defect or awareness of potential danger, please contact Patriot Equipment at 1-800-264-6587
immediately.
LIGHTING AND MARKING
It is the responsibility of the customer to know the lighting and marking requirements of the local highway authorities and to
install and maintain the equipment to provide compliance with the regulations. Add extra lights when transporting at night or
during periods of limited visibility if necessary.
SAFETY EQUIPMENT
SERIAL NUMBER
Danger!
Snout Cone V2.1
4
Advertisement
Table of Contents
