Installation - Pentair STA-RITE SILENTFLO SF550100 Owner's Manual

INSTALLATION

SilentFlo is electrically connected. Ensure that it is isolated from
electrical supply during installation and any subsequent service
work.
The pump should be installed and serviced by a suitably qualified
person in order to avoid hazard.
These instructions are a guide only. Should you the installer or owner
of the product be unfamiliar with the correct installation or operation
of this product you should contact a suitably qualifed person for
advice.
Freezing conditions will damage the unit, as water expands as it
freezes. Ensure that Silentflo is located so that it is not prone to
freezing, or ensure that the product is disconnected and dried of
water during cold conditions.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
4 SILENTFLO ™ Pool Pump Owner' s Manual
The pump operator or owner must be provided with this owner' s
manual. This must be read before operation, and followed during
operation.
NEVER run pump dry. Running pump dry may damage seals, causing
leakage and flooding. Fill pump with water before starting motor.
If pump has been pressure tested, ensure pressure has been
released before removing trap lid. Do not block pump suction. To do
so with body may cause severe or fatal injury.
Small children using pool must ALWAYS have close adult supervision.
Pump suction is hazardous and can trap and drown or disembowel
bathers. Do not use or operate pump, pool/spas if a suction outlet
cover is missing, broken, or loose. Follow the guidelines below for a
pump installation which minimises risk to users of pool and spas.
Fire and burn hazard. Modern motors run at high temperatures. To
reduce the risk of fire, do not allow leaves, debris, or foreign matter
to collect around the pump motor. To avoid burns when handling the
motor, let it cool for at least 20 minutes before trying to work on it.
SILENTFLO™ Pool Pump Owner' s Manual
INSTALLATION
5