Troubleshooting - ATN Voyager 2IA User Manual

• Keep lens cap/daylight filter on when not in use.
• Avoid contact with dust, steam, and gas.
• The Voyager is not harmful to the user or the environment.
• Do not disassemble except to clean the front lens and the eyepiece: it will void your war-
ranty.
• Evaluate the scopes function by looking through it in a lit environment with the daylight filter
lens cap on. Never use in daylight without the daylight filter lens cap on.

TROUBLESHOOTING

Q : Flashes, flickers, or clicking occur while operating
S: If it occurs within the first five minutes of inserting new batteries, it is normal and the device
will resume normal operation soon thereafter. If it occurs for more than 10 minutes, contact
your dealer or other authorized representative for instructions.
Q : Dark spots on screen.
S: These are cosmetic blemishes in the intensifier tube or dust particles accumulated on the
screen. Just like a TV, night vision intensifier tubes attract dust particles. These are easily
cleaned using photo-type cleaning equipment.
Q : Image not clear.
S: Adjust front lens at night. If problem persists, turn on IR.
Q : Fixed-pattern noise in a honeycomb shape.
S: Usually a cosmetic blemish characterized by a faint honeycomb-type pattern. It usually
occurs when viewing very bright lights. Adjust the brightness of the unit to reduce noise.
Q : LED's keep turning off after a few moments.
S: This is the normal mode of operation. It will increase your scope batteries life and make you
harder to detect
4