Advertisement
喷孔杂质或结垢会导致水流变
形袁流量变小遥 打开水源袁用力按
压或摩擦橡胶喷孔袁去除杂质或
水垢遥
拆下手持花洒渊8冤遥 先将滤网垫片
渊6冤和毡垫渊9冤从手持花洒中依次
取出遥 用热醋清洗滤网垫片上的
滤网袁清洗垫片滤网和毡垫遥 重新
将毡垫和滤网垫片装入手 持花
洒遥 重新装回手持花洒遥
用带尖工具把白色塞扣拨下遥 用
2.5mm 六角扳手(客户自备)把四
个螺钉拆下遥 将上下盖拆下后袁即
可拆下云雾式出水口遥
用白醋浸泡 30 分钟后即可清除污
垢遥
确保 O 型圈的位置正确遥
按顺序装回所有零件遥
适用于所有加工处理过的表面院以中性肥皂水
清洗镀层表面袁再以干净的软布彻底擦干整个
表面袁许多清洁剂袁比如氨水尧去污粉及洁厕灵
等袁会对电镀表面造成伤害袁切忌使用遥
有磨损性的清洁用具或清洁剂也不可使用于
科勒牌的水龙头及其配件上遥
1130591-2-A
8
9
6
Grommet
塞扣
Screw
螺钉
Kotton Spray
云雾式出水口
O-ring
O型圈
All Finishes: Clean the finish with a mild soap and warm
water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as
ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets
and fittings.
Any debris or mineral build-up may cause
the flow stream to become distorted or
reduce the flowrate. To remove the debris
or mineral build-up, run water through the
handspray, firmly press or rub your finger
back and forth across the rubber nozzles.
Remove the handspray(8). Take out the
screen washer(6) and the filter(9) from
the handspray. Clean the filters of the
screen washer by soaking them in warm
vinegar. Clean the screen washer and
filter. Reinstall the filter and screen washer
into the handspray. Reinstall the
handspray.
Use a suitable tool to remove the four
grommets. Using the 2.5mm hexagon
wrench(not supplied), remove the four
screws. Separate the sprayplate assembly
into its individual componets.
Clean the kotton spray by soaking them in
O-ring
warm vinegar for 30 minutes.
O型圈
Make sure that the O-rings are
located correctly.
Reassemble the components in reverse
order.
Advertisement
